ASSEMBLY AND OPERATION MANUALWarrantyAquaCraft™will warrant this kit for 90 days after the purchase from defects in materials orworkmanship. AquaCraft
It is a good idea at this point to install the rest of your radio gear.❏ 1. Locate the included foam padding and cut a 2" x 4" [51x 102mm] s
❏ 3. Make sure the engine is neutral (use the stand to holdthe engine straight) and use a felt-tip pen to make a markwhere the pushrods meet the holes
secure it by tightening the socket head screw (3/32"[2.5mm]) as shown. Cut off the excess after making surethat there is enough throttle cable to
❏ 5. Spread the sides of the canopy so that the holes at therear fit over the body posts and replace the body pins. Youare ready for action!• Standing
PROPELLER SELECTIONThe Top Speed 2 has been tested with many engine/propellercombinations. A balanced Octura Models X440 has workedwell with both stoc
PROPELLER DEPTHThe depth of the propeller has an influence on both engineperformance and boat handling characteristics. Running theengine with the cen
Gently pull the rubber drain plug located on the transom andallow any water that may have found a way inside the hull todrain out. Be sure to replace
All three national organizations offer both stock andmodified engine classes for tunnel hulls like the Top Speed2. Participation by those new to the h
• Before running your Top Speed 2, it is a good idea tocheck the water-cooling system to make sure all tubesare properly connected and unblocked.• Che
1919Order # ItemHCAB6704 Rubber Drain PlugHCAB9042 Recovery PadsHCAB6700 Waterproof Switch Boot w/ON-OFF PlateHCAB8602 Assembled 3-channel Radio BoxHC
INTRODUCTION...2SAFETY PRECAUTIONS ...
All pictures, descriptions, and specifications found in thisinstruction manual are subject to change without notice.AquaCraft maintains no responsibil
compound on self-tapping screws. The thread-lockingcompound may damage the hull. IMPORTANT: Use thread-locking compound on any fastener that is thread
Carefully remove your Top Speed 2 and stand from the box.Carefully remove all remaining parts bags from the box. Youmay wish to keep the box in order
6❏ 1. Use a Phillips head screwdriver to remove the two (2)3 x 10mm screws holding the steering arm to the upperswivel bracket as shown.❏ 2. Remove t
❏ 7. Remove the template and use a 3/16" [5mm] (or13/64") drill bit to increase the size of the hole to install the6-32 brass thread insert
❏ 1. Use CA glue or epoxy to attach the servo tray atop theservo tray supports as shown. The servo tray supports havealready been glued in place for y
❏ 7. Put a bead of CA glue on the rubber throttle pushrodseal and insert it in the radio box as shown.❏ 8. Place the radio box into the radio box sea
Comments to this Manuals