Aquacraft SuperVee 27R User Manual download pdf (Page 8)

8. Use a 1.5mm hex wrench or hex driver to loosen the

set screw that holds the ﬂ ex coupler to the motor shaft.

You don’t have to remove the set screw; just loosen it.

9. Using a 2.5mm wrench, loosen and

remove the two motor screws.

10. Remove the motor from the boat and spray the entire motor

with moisture displacer. Make sure to fully saturate the motor.

This is also a good time to spray the displacer through the water

jacket. Removing any water from there is equally important.

11. After you have the motor ﬂ ushed out, re-oil

the motor bearings.Reinstall the components

by reversing the above procedure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Aquacraft SuperVee 27R User Manual Page 8