Aquacraft VS1 User Manual download pdf (Page 10)

4. Next, epoxy the front (longer) upright into the base.

5. To help strengthen the area that the O-rings attach to, it is

a good idea to place a few drops of thin CA on the hook end

of the uprights.

6. The completed mount.

INSTALLING THE FUEL TANK

Parts and tools you are going to need:

Pre-built mount (VS1 Kit)

Four 2 x 10mm wood screws (VS1 Kit)

Small Phillips screwdriver

Fuel tank (VS1 Kit)

O-rings (VS1 Kit)

Fuel line

1. Align the fuel tank mount’s front tabs in front of the forward

mounting block. Screw the mount in place using the four

2 x 10mm wood screws provided.

2. Carefully slip fuel line onto each ﬁ tting on the fuel tank.

Place the fuel cell in the mount cradles and secure with the

included O-rings. If you like, you can cut the fuel line to length.

When doing so, make sure you have enough line length to

place the lower fuel line to the carburetor and the upper line

to the mufﬂ er pressure. Note: Please use a fuel ﬁ lter from the

tank to the engine carburetor.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Aquacraft VS1 User Manual Page 10