Aquacraft Reef Racer 2 User Manual download pdf (Page 1)

Warranty

• AquaCraft

™

will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft will

either repair or replace, at no charge, the incorrectly made part.

• Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase

and we must see it before we can honor the warranty.

• To return your Reef Racer 2

™

for repairs covered under warranty, you should send your boat to:

Hobby Services

3002 N. Apollo Drive, Suite 1

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F

E-mail: hobbyser[email protected]

ASSEMBLY AND OPERATION MANUAL

™

Before Building:

Thank you for purchasing the Reef Racer 2! This manual contains the instructions you need to safely operate and maintain

your boat. We want the operation of this boat to be a success so BEFORE preparing the Reef Racer 2 for action please read

this manual thoroughly. If for any reason you think that this model is not for you, return it to your local dealer immediately.

PLEASE NOTE: Your hobby dealer cannot accept a return on any model after final assembly sequence has begun.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Before Building:

Warranty• AquaCraft™will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft willeither repair or repl

Page 2 - SAFETY PRECAUTIONS

• Adult supervision is strongly recommended! Childrenshould be warned about the dangers of playing in closeproximity to water.• Do not attempt to

Page 3

❏ 2. Slide off the battery door on the bottom of thetransmitter. Install 8 fresh “AA” batteries into the bottom of thetransmitter in the co

Page 4 - THE REEF RACER 2

❏ 5. The canopy is held to the deck of the Reef Racer 2 withhook & loop material. Open the battery compartment of the ReefRacer 2 by gently lifti

Page 5 - MAINTENANCE

• R/C models produce vibrations which will cause screws,nuts, bolts, etc, on your model to become loose overtime. It is important to make su

Page 6 - ORDERING REPLACEMENT PARTS

❏ 2. Loosen the 1.5mm set screw located at the rear of thedrive coupler assembly, and pull the shaft out as shown.❏ 3. After applying lubricant to the

Page 7

• For “drag racing” place the buoys similar to the above sketch.•For “oval racing” place the buoys similar to the abovesketch. NOTE: The above

Page 8

CHECK OUT THESE OTHER SENSATIONAL AQUACRAFT BOATS!Check us out on the web at www.aquacraftmodels.com and watch for more exciting AquaCraft releases co

Comments to this Manuals

No comments

Aquacraft Reef Racer 2 User Manual Page 1

Browse online or download User Manual for Water equipment Aquacraft Reef Racer 2. AquaCraft Reef Racer 2 User Manual

Summary of Contents

Comments to this Manuals

Aquacraft Reef Racer 2 User Manual Page 1

Browse online or download User Manual for Water equipment Aquacraft Reef Racer 2. AquaCraft Reef Racer 2 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Water equipment Aquacraft Reef Racer 2