Aquacraft SuperVee 27R User Manual

aquacraftmodels.comWARNING:• NEVER attempt to swim after a stalled RC boat! • Never operate your RC boat while standing in the water.• Never operat

104. Before tightening the cable coupler, make sure to leave a 4 or 5mm distance between the back of the strut and the front of the drive dog. This wi

11TUNING TIPS AND PROP INFOSTRUT: The type of strut your boat is supplied with is called a “Stinger” strut. Tilting the strut up lifts the prop out of

122. Using the same 3mm hex wrench and a 7mm nut driver (Note: you are going to need a thin wall nut driver) remove the two center strut bolts and set

135. With the strut in position replace the two center bolts. You can use a metal ruler or straight edge to help view your changes.The point regarding

14CG: Adjusting the CG or center of gravity of the boat has a lot to do with how tight the boat rides as well as the how the boat “fl ies” as it exits

15Below are a set of racing rules provided to use from our friends of the Puget Sound Fast Electric Model Boat Club based in Washington State. These r

ALSO AVAILABLE FROM AQUACRAFTUL-1 SUPERIOR™ FE HYDRO RTR (AQUB20**)Unleash brushless lightning with the UL-1’s 2030kV motor and 60A ESC; 2.4GHz radio

2INTRODUCTION & DESCRIPTION CHANGESThank you for purchasing the AquaCraft SuperVee 27R. We at AquaCraft want the time you spend with your boat to

3OTHER FEATURES:Hand-laid fi berglass constructionHigh-gloss painted fi nishWater-resistant radio boxBrass stuffi ng tubeLow-friction cable guide.150&quo

4FINAL ASSEMBLY1. Install 4AA batteries into the transmitter. Turn on the transmitter, making sure it’s working by viewing the LED on the front. The L

5START UP & OPERATION PROCEDURE1. Turn on your transmitter, taking note that the power light is illuminated.2. Stand clear of the propeller and pl

6MOTOR MAINTENANCEAfter each day of operation we feel it’s best to remove the motor, fl ush it out with a moisture displacer and re-oil the bearings. Y

74. Remove the two water lines that attach to the motor cooler.5. Unplug the three 4mm connectors leading to the motor.6. Use a 2.5mm ball driver or h

88. Use a 1.5mm hex wrench or hex driver to loosen the set screw that holds the fl ex coupler to the motor shaft. You don’t have to remove the set scre

9SHAFT MAINTENANCEAfter each 5 or so runs and after your day of running it’s a good idea to re-lubricate the drive cable. Here are the tools and suppl